Easy Testing with the Training CMM cont'd (ver. 3.0)
Print Friendly View
written: 07/10/2006
last modified: 03/22/2024

INTRODUCTION

Here are a couple of easy things to test when evaluating QC-CALC Real-Time with the Training CMM.

Automatic Part Switching

Whenever a new part program is run and data is sent to QC-CALC, a new database is automatically created for the part program. QC-CALC then switches the file that is open to show the new data.

When data from a previous part program arrives, QC-CALC automatically matches the data to the previous part program, switches back to that part program's database, and appends the data. You'll notice it simply picks up right where it left off.

How to Test It:

  1. In the Training CMM, simply name the Part Name something you'll remember such as "Part Test 1".
  2. Inspect a few parts by clicking Inspect multiple times.
    QC-CALC Real-Time will plot the data as it arrives.
  3. Change the Part Name to something different such as "Part Test 2" and click Inspect a couple of times.
    QC-CALC will switch to the new Part Program and begin plotting the new data.
  4. Change the Part Name back to the original ("Part Test 1") and click Inspect a few more times.
    You'll notice QC-CALC switch back to the original part program and add the data to the end of the plots.

Sending Non-Measurement Data to QC-CALC

The Training CMM allows you to test sending non-measurement factors to QC-CALC by providing 1 numeric and 1 text factor. These are visible in QC-CALC Real-Time in the Point Properties window as well as various reports (such as the First Article Report).



How to Test It:

  1. Open QC-CALC.
  2. In the Training CMM, create a new part program and name it "Part Test 3" with 12 Features.
  3. Inspect 3 parts.
  4. In QC-CALC Real-Time, choose Window > Point Properties.
    The Point Properties window will appear at left.
  5. Approximately half way down the Point Properties window, you will see "NumFactor 1" and "TxtFactor 1".
  6. As you move your mouse over the first 3 points on each plot, you will notice that the values for these fields are not set.
  7. In the Training CMM, there are two pairs of Name/Value fields corresponding to Number and Text at the top of the screen.
  8. For the Number field - add a Name called "Lot Number" and a value of "333".
  9. For the Text field - add a Name called "Operator" and a value of "Bob" (or your own name).
  10. Inspect another 5 parts by clicking Inspect 5 times.
  11. In QC-CALC, move your mouse over all 8 points and you should see that the "NumFactor 1" and "TxtFactor 1" have been renamed to "Lot Number" and "Operator" respectively for all parts. For the last 5 parts, you will see the values you added.

Applies To

QC-CALC Enterprise v.3.00
QC-CALC Real-Time v.4.10
QC-CALC Real-Time v.3.00